New to this site, wanting help with Tornado bowl design

[Jeff@elksteele]

I saw a youtube video showing a beginner how to make a dizzy bowl. I was impressed with the excel like graph print and the colored design for each ring. I searched and found this site and software. From the description I purchased the Segment Pro software as it described the design of a tornado bowl. Now that I am looking thru it, I do not see the items I wanted. Is there a place in that software to show ring sizes and cut-out patterns or does one of the other software programs have that instead?

 

[mfisher]

In SP and WTP the cut list is in the summary section.


Dizzy bowls are mostly done from the bowl from a board concept.
Here is writeup I did awhile back.

SW Dizzy Bowl

Here is my WTP plan for the SW Dizzy Bowl. Please note while the plan shows rings 3 through 37 as segmented rings. The rings are cut from a blank. If I used "disk" , you only get the OD (outside diameter). By selecting "flat", you can get both the OD and ID (inside diameter). These...

woodturnerpro.com