S
stevie
Guest
I get a supply of scrap cutoffs from local cabinet shop and been using them for other thing but want to use them now for segment turning.
Most pieces are cut off from door frames or styles ,the grain runs top to bottom ( parts are on average 3/4 thick, 2 to 4 wide and lengths are random)
I want to be sure that these will work.
I plan to resaw them to get the thickness all the same and saw them to widths needed,
I have had the software for a while and been doing some plans with both WTP and SP, but have not done a complete figure and not done any glue-ups yet.
Any thoughts on this or pointers,
I will even be open to any samples or plans that someone has done and be willing to share.
Most pieces are cut off from door frames or styles ,the grain runs top to bottom ( parts are on average 3/4 thick, 2 to 4 wide and lengths are random)
I want to be sure that these will work.
I plan to resaw them to get the thickness all the same and saw them to widths needed,
I have had the software for a while and been doing some plans with both WTP and SP, but have not done a complete figure and not done any glue-ups yet.
Any thoughts on this or pointers,
I will even be open to any samples or plans that someone has done and be willing to share.