E
Eauston
Guest
Hi all,
I am attempting to create a disk using lamination pro for an open segment piece to use as my base. My issue is that I've come up short on both attempts. Using the lamination wizard I've selected my board widths. Then I select my repeating units and cut details. Moving onto gen 1 then select disc view I find the pattern of the disk. I then look at the radial view and this is where I loose it. First the lamination length at the bottom with the 20% allowance doesn't give me enough length for the shown pattern. I have tried both single unit and repeat unit. I have set my clipping region. I am not sure what I am missing here. I've read the tips & tricks, watched the video. Any pointers from users would be greatly appreciated. Thanks!
I am attempting to create a disk using lamination pro for an open segment piece to use as my base. My issue is that I've come up short on both attempts. Using the lamination wizard I've selected my board widths. Then I select my repeating units and cut details. Moving onto gen 1 then select disc view I find the pattern of the disk. I then look at the radial view and this is where I loose it. First the lamination length at the bottom with the 20% allowance doesn't give me enough length for the shown pattern. I have tried both single unit and repeat unit. I have set my clipping region. I am not sure what I am missing here. I've read the tips & tricks, watched the video. Any pointers from users would be greatly appreciated. Thanks!