Inserting a picture into 3D Design Pro

[sevansx]

When trying to insert a photo into 3D Design Pro, I used 'Insert Background Photo'. The photo turns 90 Degrees. How to I properly insert a photo into 3D Design Pro?

 

[Glenn McCarron]

I would try just to resize the picture ever so slightly then retry uploading it. I have found a few websites that seem to flip pictures 90 degrees for no reason and this works for me.

 

[mfisher]

In 3D design go to :
Tools / Background Photo / Add Replace
within the pop up window navigate to where the photo is located at on your pc. Make sure the photo is orientated correctly before importing.

 

[sevansx]

I would try just to resize the picture ever so slightly then retry uploading it. I have found a few websites that seem to flip pictures 90 degrees for no reason and this works for me.

Thanks... A small reduction did the trick..