J
Jim Westmoreland
Guest
Hi Lloyd,
When I created a design using lamination pro it only will save some of the info. In other words the width of Kerf, width of strips on either side of Kerf and the height of the curtain are not saved. Also when I print the directions it transposes the Kerf with the Strip width. This is on a Southwest Design. Have you had any other reports of this issue ?
Thanks,
Jim
When I created a design using lamination pro it only will save some of the info. In other words the width of Kerf, width of strips on either side of Kerf and the height of the curtain are not saved. Also when I print the directions it transposes the Kerf with the Strip width. This is on a Southwest Design. Have you had any other reports of this issue ?
Thanks,
Jim