• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.
  • Due to a scam attack, the gallery is temporarily turned off. I am working to get this fixed but I have some other things that are higher prioriity. I do hope to have it back soon and there shouldn't be any changes to the content. At least, that is the hope.

Does WTP take the width of the saw blade when calculating board lenths?

T

tgiro

PRO Member
When I use WTP it tells me the Economy Board Length and Grain Match Board Length.

When the software is telling me those lengths, does it take the width of the saw blade into account? If I have a segment that has 2-1/8" Segment Edge Length and I'm using a 1/8" thick blade, then I'm actually cutting 2-1/4" from the board at the outside edge of the segment.
 
Yes. It takes into account the saw kerf and the number of segments for the ring.
Remember you are flipping the board each cut, so one edge already has the angle cut done.
 
You must log in or register to reply here.
Back
Top