First Feature Ring Help

Discussion in 'Segmented Turnings Forum' started by Mike Sawyer, Mar 3, 2019.

  1. Mike Sawyer

    Mike Sawyer PRO Member

    I am working on my first segmented bowl with a feature ring, a simple chevron to start. I modified the existing design, renamed and filed it. I now need to print out the instructions and I can not get an existing feature ring design open so I can print out the detail. I understand how to print the build instructions if I start a new design but I can not re-open an existing design.
     
  2. mfisher

    mfisher Super Moderator Staff Member

    It would be helpful to know which software you are using. WoodturnerPro , Segment Pro.
    Did you use Lamination Pro to design and save your Chevron? If so, LP would have the instructions you need.
    WTP or SP would only have the segment dimension for the featured ring. Bringing in the "Chevron" in WTP or SP as a wood species is nothing more than a image file. There would no instructions on how to build the chevron.
     
  3. Mike Sawyer

    Mike Sawyer PRO Member

    I did use Segmented Pro and did design the ring in Lamination Pro. I did search for .lam files but could not find it. Where are the supposed to be stored? Thanks for your help.
     
  4. mfisher

    mfisher Super Moderator Staff Member

    When you installed LP there should have been a folder created in your Document folder labeled My Lamination Pro.
     

Share This Page