• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Search results

  1. Ken Sherwin

    Question about WTP

    Having used Segment Pro successfully for several years, I now discover a need for some features of WTP. While most of it is straightforward, I can't find anything that tells me what the 'Vertical Spacers' value is or what I should do with it. Can anybody help me understand?
  2. Ken Sherwin

    Segeasy videos

    When I go to segeasy.com to see Jerry's videos now, they come up blank on both my phone and computer. Does anybody else have that problem? I want to refer some newbies to them but not if they're dead.
  3. Ken Sherwin

    Beating a dead horse (another ring flattening idea)

    I tried another idea to easily flatten rings. 1. I put a ring on the spindle with Cole jaws. I straightened up the sides of the ring but I'm not good enough to make a glue-ready joint with a bowl gouge. Then I scribbled on the cut face with a pencil. 2. I mounted a 12" flat sanding disk...
  4. Ken Sherwin

    Steps to produce a basic segmented vase

    I was asked to create a step-by-step set of instructions to help bring somebody familiar with saws and lathes up to speed with segmenting. The attached document was the result. I hope you find it useful.
  5. Ken Sherwin

    Segment Pro question

    Is there a way to overlay the desired profile we enter in the upper left panel onto the resulting segments profile in the lower left panel so I can see any tight spots?
Back
Top