rtaylor
PRO Member
I just finished up a vase with a 2nd generation feature ring. I had real difficulty making those centerline cuts. I found that the laser method is really not accurate enough unless the laser set up is plumb with the saw top. If it is not perpendicular to the saw table, but at a slight angle, then the position you set for the blade at the saw top is off by the time you line up 3/4 inch higher. I found that the laser dot is fuzzy and easy to get off by 1/32 to 1/16. The relative method was better but still off somewhat. All of this tends to get cumulative which can make things go south in a hurry. Has any one just tried to set the fence and rip center line to centerline? This was a great source of frustration and the results were less than perfect.
Thanks
rtaylor
Thanks
rtaylor