-
Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.
Adding/Deleting rows
- Thread starter tschmath
- Start date
Yes and No. 
Using WTP you can add and delete rows. You have full control over each ring.
In SP because it is rules based you cannot remove or add certain rows. You can change the height of rings and size of the vessel that will change the number of rings for that vessel. You can change the height of the featured ring.
Using WTP you can add and delete rows. You have full control over each ring.
In SP because it is rules based you cannot remove or add certain rows. You can change the height of rings and size of the vessel that will change the number of rings for that vessel. You can change the height of the featured ring.
Ken Sherwin
PRO Member
I wanted to change the height of each ring in an open segment vase that had a narrow neck so that every segment was essentially square. Segment Pro doesn't do this, of course, but that's all I knew. I set the ring height at 0.100 which gave me 90 rings! Then I exported the segment data to Excel where I combined adjacent rings until the total height matched the SEL, reducing the ring count to 12.
Now that I've used Woodturner Pro, I know I was using a screwdriver as a hammer. One of these days soon, I intend to turn that plan into wood but there are other pieces in front of it.
The point is that while there is more than one way to get something done, some are better that others. Using the right tool is typically easier.