Andrew Rothwell
PRO Member
Greetings all -
Not sure which forum to post this in - so it's going here. I am using a wedgie sled, based on Lloyds Design, and using the 32 segment wedgie that I bought from him too.
However when I cut 32 segments there is a HUGE discrepancy in the ring. However if I take 2 segments out - it's perfect. Just to confirm - the wedgie says 32segs 11.25 degrees. (11.25x32=360) so I know that the math works out.
So I figured that something is wrong - I had a friend draw up a 32 segment wedge on CAD, that I then imported into my X-Carve, cut it out. Well the angles are the same as the Plastic purchased wedge. This is the first time using the 32 wedge.
I actually cut up a large project using a 32 segment pattern that I made with segeasy - well every single ring had to have 2 segments pulled, needless to say that the pattern did not work, and I ended up abandoning the pattern and went with a chaotic pattern just to save the wood.
Please help a confused person
Not sure which forum to post this in - so it's going here. I am using a wedgie sled, based on Lloyds Design, and using the 32 segment wedgie that I bought from him too.
However when I cut 32 segments there is a HUGE discrepancy in the ring. However if I take 2 segments out - it's perfect. Just to confirm - the wedgie says 32segs 11.25 degrees. (11.25x32=360) so I know that the math works out.
So I figured that something is wrong - I had a friend draw up a 32 segment wedge on CAD, that I then imported into my X-Carve, cut it out. Well the angles are the same as the Plastic purchased wedge. This is the first time using the 32 wedge.
I actually cut up a large project using a 32 segment pattern that I made with segeasy - well every single ring had to have 2 segments pulled, needless to say that the pattern did not work, and I ended up abandoning the pattern and went with a chaotic pattern just to save the wood.
Please help a confused person