G
grossl
Guest
I couldn't find a forum just for Lamination Pro and where, so I decided to post my question here. Please move it if it needs to be somewhere else.
I just wonder if there is a video of someone making a 2nd generation lamination. I have seen the videos of using the software, but I would like to see someone actually putting it to use. In particular, I can't figure how to make the 2nd generation cuts accurate enough for them to be cut in the same place on the declining slope.
Thanks
Ron Grossl
I just wonder if there is a video of someone making a 2nd generation lamination. I have seen the videos of using the software, but I would like to see someone actually putting it to use. In particular, I can't figure how to make the 2nd generation cuts accurate enough for them to be cut in the same place on the declining slope.
Thanks
Ron Grossl