D David Muehlbauer PRO Member Mar 10, 2019 #1 Is there a way in Segment Pro to make the bottom segmented, rather than a solid disk?
Bob Beaupre Administrator Staff member Mar 10, 2019 #2 Not directly. Make note of your base diameter. Start a new bowl make a ring the same diameter. You now have the information to make that ring
Not directly. Make note of your base diameter. Start a new bowl make a ring the same diameter. You now have the information to make that ring
mfisher Super Moderator Staff member Mar 10, 2019 #3 Bob is correct. SP does not allow you to change the base from disk to segmented. If you have Wood Turner Pro you can change the base to a disk.
Bob is correct. SP does not allow you to change the base from disk to segmented. If you have Wood Turner Pro you can change the base to a disk.
Bob Beaupre Administrator Staff member Mar 11, 2019 #4 I would like to also mention that making a full segmented base right is not a good ides. It will eventually pull it self apart. If you want to make a segmented base make it several thinner rings and use a floating base. Attachments floating_base.pdf 1.4 MB · Views: 35
I would like to also mention that making a full segmented base right is not a good ides. It will eventually pull it self apart. If you want to make a segmented base make it several thinner rings and use a floating base.