Okay, I understand the system you've described for cutting segments to align grain. Now, does that system work with a Chevron design? I just set up a chevron on a flat configuration such that each chevron was absolutely perfectly aligned with it's neighbor. I cut off the dog ears on both sides and started cutting the bevels. If I set the newly cut, angled pieces together, the outside would line up while the INSIDE was a mess. Totally off line and looking horrible. I was using an Incra 1000 do do the angles with, and they are accurate. It requires flipping each piece.
So, should I "Flip" cut a sliver to set the angle, and flip again to cut to the correct width? I've probably not expressed that question too clearly, but this is the second ring I've tried to make and I'm weary of wasting wood. A little help please.
thanks