Stephen Roberts
PRO Member
In the spirit of observing anomalies (bugs?, features?, etc) in Segment PRO, I have encountered the following in the design of a simple open segment bowl:
1) The Actual Height in the Bowl Summary Cutaway View is 50.75” while the Height in the top right window shows a Height of 7.25 in. (the latter is correct)
2) The Summary tab for the bowl lists the species, but the number of segments in each species is completely incorrect and does not approximate the Bowl View and Ring View. For example, 11 of 19 rings are shown as Wenge while there are no rings in the design that are Wenge only.
3) The Lgth calculations in the Species table is somewhat suspect since in one case there is only one Maple segment whose Lgth is 1.4 while its SEL is 1.5.
Perhaps I encounter these anomalies because of my limited experience with the software, so I look forward to enlightenment.
1) The Actual Height in the Bowl Summary Cutaway View is 50.75” while the Height in the top right window shows a Height of 7.25 in. (the latter is correct)
2) The Summary tab for the bowl lists the species, but the number of segments in each species is completely incorrect and does not approximate the Bowl View and Ring View. For example, 11 of 19 rings are shown as Wenge while there are no rings in the design that are Wenge only.
3) The Lgth calculations in the Species table is somewhat suspect since in one case there is only one Maple segment whose Lgth is 1.4 while its SEL is 1.5.
Perhaps I encounter these anomalies because of my limited experience with the software, so I look forward to enlightenment.