J
jez
Guest
just bought woodturner pro --don't know how to start --not computer savy ---don't know what I'm doing---any suggestions--tks,joe
Hi Joe,
make sure urge you watch the tutorials as they will show you everything you need to know about the software.
if you start with 3D Design PRO, start with this tutorial:
http://woodturnerpro.com/content.php?r=136-Introduction-to-3D-Design-PRO
i would leave Lamination PRO until you have a good working knowledge of the other two programs. To see the other tutorials, click the category 'Software Tutorials' in the forum.
the 3D Design Pro sample files are in a folder named 3D Vessels that was created in the root of your Documents folder.
lloyd
make sure urge you watch the tutorials as they will show you everything you need to know about the software.
if you start with 3D Design PRO, start with this tutorial:
http://woodturnerpro.com/content.php?r=136-Introduction-to-3D-Design-PRO
i would leave Lamination PRO until you have a good working knowledge of the other two programs. To see the other tutorials, click the category 'Software Tutorials' in the forum.
the 3D Design Pro sample files are in a folder named 3D Vessels that was created in the root of your Documents folder.
lloyd