Suggestion: On printout, show how much laminate to make

Discussion in 'Lamination PRO Support Forum' started by Scott Gordon, Dec 20, 2018.

  1. Scott Gordon

    Scott Gordon PRO Member

    On the printout generated by Lamination Pro, it would be nice to have a table printed that said for X repeating units, start with Y-inches of laminate. The table would have various values for X. The woodworker could extrapolate in between as needed. I know this information shows on the screen when using the software, but if you didn't remember what it said, you have to go back into the software when you're ready to produce the design.
     

Share This Page