Recent content by woodturnerVA

Thanks. I did not think of that.

I am trying to figure out if once a bowl in designed, is there any way I can insert narrower accent rows in between the shown bowl rows?

THANKS I really want to try this and maybe give all 11 grandkids their own ornament

Are these project videos transferable to my computer. My 14 year old granddaughter (and my turning buddy) would probably like to see and try this.

Hopefully, I am the only one who has printed out the plan sheets for the alignment for each segment angle for the corresponding segeasy plates and double checked the measurements. I found the 8 inch measurements for the holes to hold the fence block and the threaded inserts to be about 1/4"...

Lloyd did a great job. Everything appears to work correctly and I am thoroughly enjoying it. Thanks again!

Left a phone message this morning. I am home.

I just redid the above and followed your instructions to the letter. All 3 other programs started up fine. SegPro did exactly what it did previously. It acts like it wants to start, asks for the disc source, then shows "Fatal error during install"

I just deleted all 4 programs from the computer. Then I reloaded from the backup disc. 3 of 4 work fine. Segment Pro keeps asking for the disc and then gives me a "fatal error" message. Now what?

Windows 10. The others seem to be OK. I had 1 error message about something unprogrammed.

I actually have the software packages. That said, I have been unable to get Segment Pro to open. I tried reloading to no avail. I tend to be somewhat technologically challenged so I could use some coaching on how this works. Woodturner Pro opened. THANKS

I am Pete and I have been doing segmented turning for about 1 year. I have, from time to time, lurked on the forum and gotten interesting information. I decided to try open segmented and so, here I am.