martyn
PRO Member
this is my table saw sled i built for my axminster ts250 table saw, ives used two layers of 12mm birch plywood laminted together, they run on nylon runner on the table saw grooves.
i used a router to put 2 arched t grooves in the bed in which the fence swings and locks in. The right side of the saw there is a adjustable stop. From this jig i have been able to create excellent fitting segments although i have considered make a couple of dedicated jigs for different angles as i feel i might be more conveinent although once set correctly this jig works a charm. timbers have to be planed straight and true as any slight bend can ruin the segmented ring even if the fence is set correctly as i've found out.
what do you think, questions comment welcome of course
i used a router to put 2 arched t grooves in the bed in which the fence swings and locks in. The right side of the saw there is a adjustable stop. From this jig i have been able to create excellent fitting segments although i have considered make a couple of dedicated jigs for different angles as i feel i might be more conveinent although once set correctly this jig works a charm. timbers have to be planed straight and true as any slight bend can ruin the segmented ring even if the fence is set correctly as i've found out.
what do you think, questions comment welcome of course