gjane14
PRO Member
I might have found an answer to my question while reading through past posts in this forum but need to clarify it in my head with you guys... Being new to segmented turning, SP and just flat out not thinking it through, the summary page prints out the angles at what the angle would be on one side of the cut? So for example: I planned out a 24 seg bowl, the summary called for 7.5 deg angle and without thinking about it, I cut 24 segments using my wedgie sled at 7.5 degrees. Thinking I did oh so good with these cuts, I go to dry fit and as you can imagine i made a half ring, I looked at my wedgies for 24 seg and it says 15 degrees on it, so then I realized I wasn't paying attention to the segment number on the wedgie but the degree angle on it.
So to clarify, when the summary prints out the angle it is in fact just one side and I need to keep in my head to multiply that number by 2, correct? Or have I confused myself even more?
So to clarify, when the summary prints out the angle it is in fact just one side and I need to keep in my head to multiply that number by 2, correct? Or have I confused myself even more?