G
gaparrott
Guest
Hello,
I had downloaded and installed the WoodturnerPro, LaminationPro, and 3D DesignPro version 3 software and installed it. I could not get 3D DesignPro to transfer. The button is greyed out. I tried the suggestions about rebooting in the other thread. No help. Uninstalled, reinstalled, no help.
Finally I uninstalled the v3 and installed the v2.1. The transfer works on v2.1. is there a minimum software maintenance level or hardware level necessary for v3?
Thank you
George Parrott
I had downloaded and installed the WoodturnerPro, LaminationPro, and 3D DesignPro version 3 software and installed it. I could not get 3D DesignPro to transfer. The button is greyed out. I tried the suggestions about rebooting in the other thread. No help. Uninstalled, reinstalled, no help.
Finally I uninstalled the v3 and installed the v2.1. The transfer works on v2.1. is there a minimum software maintenance level or hardware level necessary for v3?
Thank you
George Parrott