• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Search results

  1. J

    SEL formula

    Given the notion that the number of segments divided into the circumference of a bowl gives you the Segment Edge Length, I'd like to understand why there's a difference in the SELs in Segment Pro vs a plain calculation. For example: for a 6" 12 segment bowl the formula would be (3.1416 * 6 ) /...
  2. J

    Summary has negative SELs?

    I don't understand how the SELs are getting screwed up on this plan. With 36 segments a diameter of 9.4" should have SELs of about .82" yet all this plan shows is .322". And the board length is almost 32" which, with 36 segments, implies an SEL of under 1"? More bafflingly, the smaller...
  3. J

    Having trouble with Southwest segment length

    I have been experimenting for a Southwest feature ring using Lamination Pro. After I export my segment area and load it into my bowl just fine. Everything looks great on the outside. But when I enter the bowl, I can see that my design has been lopped off on the left and right. Obviously, it...
  4. J

    Cutting wedges from strips question

    I am asking how or what jig is required to cut the wedges from a glued up strip. I have a simple chevron strip and I am unclear as to how to cut off the wedges, paying attention to the saw kerf and the alignment of the chevron wings so that they are the same length. I understand the need to use...
Back
Top