• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Recent content by mostlycold

  1. M

    3D Design Pro-->WTP-->Segment Pro

    Sorry if I'm suppose to post this somewhere else. I just watched a YouTube seminar that Lloyd did with the New England Wood Turners group which was very helpful in explaining several things that I missed earlier in my using of the software suite. He mentioned a viewer that could show the 3D...
  2. M

    Woodturner Pro

    May not be helpful, but I had a couple issues with this myself and two things cleared it up. First, if using the wedgie system, make sure you are cutting from the same side of the stock on each cut (I think Jerry refers to this as parallelism), second, make sure you are “not” using a thin kerf...
  3. M

    Crossgrain

    Thanks for the info. Normally I’d agree about cutting a bigger piece. About 30 years ago I picked up a full box of ebony pen blanks and I don’t make pens. I have an accu-slice jig for my bandsaw for slicing the blanks to 1/8”, so I figured this would be a good way to use them. So, if I don’t...
  4. M

    Crossgrain

    I’m putting a diamond feature ring together and wish to separate each segment with a 1/8” ebony spacer. If I glue in the spacers in the face grain to end grain orientation, is there enough wood movement to be problematic? Reason I ask is the feature ring height is twice the width of my ebony...
  5. M

    My LamPro Failure

    I will give the one pattern at a time a try. I tend to agree that long cuts on the table saw probably caused most of the problem. Thx for your advice, Dan
  6. M

    My LamPro Failure

    This is the video I followed using the SW design to construct diamond. Any other info or suggestions appreciated. Thx, Dan
  7. M

    My LamPro Failure

  8. M

    My LamPro Failure

    Not sure what I did wrong. Followed LamPro directions and wound up with a diamond alignment that was perfect on the first two (on left), center two the lower section was shorter than the top, the next one to the right lined up on 3 points, and looks like the last half one started lining up...
  9. M

    Hi from Alaska!

    I'm Dan Healey (handle is mostlycold) from Eagle River Alaska. I've been woodworking for 25 years and like turning small projects. I am a member of the AAW Segmented Woodturners organization as well as the Anchorage Creative Woodturners Association. Have completed a 1 week private instruction...
See more
Back
Top