• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Recent content by James Allison

  1. James Allison

    Simple (?) question about LP

    Sorry, that is confusing after I reread it. Basically, does the repeating unit include the kerf?
  2. James Allison

    Simple (?) question about LP

    Thanks for your kind words and encouragement. One other Question re: Repeating Unit, Is that the size after the cut or is it the c-c distance on the board? Jim
  3. James Allison

    Simple (?) question about LP

    Makes sense. I have built a practice board with the 1/8" setting and it looked good thru Gen 2. Gen 3 I had trouble cutting them to the same size. I wasn't sure whether I should cut the blocks to the LP block size or to work out the center of the pattern and cut to that. I ended up doing...
  4. James Allison

    Simple (?) question about LP

    lamination Pro allows optional settings for the saw kerf 1/8" and 3/32". My Thin blade produces a kerf of 0.1". Do I need to change anything in LP to account for this in calculating the block lengths or the board lengths?
  5. James Allison

    My Eagle Bowl attempt

    Great job! Thanks to Lloyd for steering me to your post as I am considering this as my introduction to turning using SegPro & LP. I'm a little confused about the horizontal cut showing the four lines, photo 1089. I can't visualize the eagle's tail. I also appreciate the hint about carving the...
See more
Back
Top