• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Recent content by Shawn Schiebrel

  1. S

    way to make faceplate rings

    No flex at all, I don't see the screws popping loose any more on this than through a metal ring. you still are screwing through the backside ( motor side ) of the faceplate into your sacrificial piece. the ring doesn't have any screw threads going into the material. As long as your screwhead...
  2. S

    way to make faceplate rings

    I was checking out the faceplates and was kinda stunned by the prices. Then I saw faceplate rings. As many of you know, these are steel rings that have holes that can be screwed into the scrap blocks, but have dove tail edges that are grabbed by standard chucks. These are even more expensive...
  3. S

    Wedgie sled calculations

    in my testing, i had no problems using a protractor and all my rings have no gaps, perhaps i just have a very accurate one. In any case, my question is this. I tested my sled using the calculations for an 8 segment ring, I know we discussed this in the other thread but for those here that...
  4. S

    Wedgie sled calculations

    Hello, I originally started this in the software support forum, but I think this is a better place for it. I use a wedgie sled, but I'm having an issue with conversions. All of the calculators that I've seen ( Woodturner pro is my fav ) have the angle for a single fenced sled. All well and...
  5. S

    Miter angle when using a wedgie sled

    How do you guys think this changing of the angle affects the length of each segment? the steeper the angle, the longer the long-side segment length. I guess I could just test a calculated ring diameter, double the angle and see if the finished ring still meets the measurement. but i'm...
  6. S

    Miter angle when using a wedgie sled

    Hello. Love the software, but i'm using a wedgie sled. I'm not using wedgies, i just set my digital protractor to the angle and off I go. But i've noticed that the miter angle in the software needs to be doubled when using a wedgie sled ( otherwise you cut double the number of segments). i'm...
See more
Back
Top