Search results

im tiring to make a box in wtp and am tiring to separate out my lid top, how do i do that?

i used a drum sander and had the rings flattened, i didn't put weight down to close the gaps as it was gluing. i wound up using sanding sealer then 120gr to 440gr and it filled in all the gaps

Very good idea, I have alot of copper wire

Great idea thank you

I have some gaps from my glueup between the rings. I'm wondering if there are any good suggestions on hiding the gaps to salvage my piece. Also I see how I messed up gluing the rings so no need to rehash that