• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Search results

  1. S

    I am stuck , using WTP in the design of a stave lid.

    That is some very helpful guidance , Thank you !
  2. S

    I am stuck , using WTP in the design of a stave lid.

    It was in my blade tilt. a little service work on the 0l' Rockwell and we are smiling some now.
  3. S

    I am stuck , using WTP in the design of a stave lid.

    Well i thank you for finding those.
  4. S

    I am stuck , using WTP in the design of a stave lid.

    I have tried to cut a compound staved lid at 30 deg. I payed close attention to my saw set up using a digital angle meter for the blade tilt and a Incra miter guage. After several attempts i feel i should ask the skilled for advice and to point out my errors. I cut my test pieces to length and...
  5. S

    Hello everyone

    Thank you.
  6. S

    Hello everyone

    Hello from beautiful Vancouver Island ! I am a year new to turning and looking forward to learning from all.
Back
Top