Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.
I have used the basket illusion software. Agree with Bob’s analysis. A little quirky but it works after you figure it out. Could be smoother to use but gets the job done.
Put wax paper down before put the ring down. No need to cut it round, just a piece you cut off the roll. Wax paper just squeezes down without effecting the glue up. Been doing this for years on the stomper and most other glue ups without ever a problem. Plus you can use apiece for several...
As Brett said export the summary to excel and change it anyway you want. Take a screen shot of the paint page and print it out. You have everything you need to build. I never print out the rings, a waste of time and paper.
8 ¾” diameter, 5 ½” high bowl with 336 open and 816 closed segments, total 1152 pieces plus the base. Woods are maple, walnut, mahogany, and bloodwood. 48 segments/ring, each ring 3/16” high. All designs completed with Segment Pro and assembled with the Lohman jig. Designed the bowl as fully...
8 ¾” diameter, 5 ½” high bowl with 336 open and 816 closed segments, total 1152 pieces plus the base. Woods are maple, walnut, mahogany, and bloodwood. 48 segments/ring, each ring 3/16” high. All designs completed with Segment Pro and assembled with the Lohman jig. Designed the bowl as fully...
I had a bladerunner and sold it. I didn't like what for me was a lack of control for cuts. I would never try to cut rings from a board with it. To directly answer your question, the bandsaw is a far better solution, even with cutting them in half. The scroll saw is good and eliminates the...
Tony, when cutting a segment out of a board of a given width, one edge of the board is the edge length, the opposite edge is nothing or close to it. When cutting the next segment, the long segment edge length is on the opposite side of the board. So the total length of two segments is less than...
Agree with Bob. I do both open and closed segments on the wedgie sled. I also stack cut so I'm cutting 2-5 segments at a time depending on how thick the segments are. Similar to what Tom Lohman was doing on the miter saw in his early videos.
Tom started this idea skipping 4. I tried this and it worked fine, but he did say at the symposium as Bob says he now skips two. I'll give that a try next time.