• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Recent content by TomK

  1. T

    Off Center

    I reallly like that idea. I also have a 3D printer and will be making one.
  2. T

    Off Center

    Lloyd, Lloyd, Please see the attached picture of what happens to a segment when it is not correctly distanced from the center. Segment "A" is in the correct position with both edges aligned with the center. Segment B is out of position thus throwing off the adjacent side of the segment to...
  3. T

    Off Center

    I got tired of the hose clamps for closed segment so I built this fixture. It will accommodate rings up to 10 inches. A #12 stranded wire wraps around the segments. The wire end is soldered in to a 1/4-20 bolt to apply tension with a nut driver. To take out the excess slack, the wire wraps...
  4. T

    Off Center

    Should you decide to build a fixture like mine, let me know if you have any questions. More than happy to help
  5. T

    Off Center

    Ok, for example if you wanted to change the open gap from 4 degrees to 3 degrees on segment rows. How would you do that?
  6. T

    Off Center

    Lloyd, Lloyd, Please see the attached picture of what happens to a segment when it is not correctly distanced from the center. Segment "A" is in the correct position with both edges aligned with the center. Segment B is out of position thus throwing off the adjacent side of the segment to...
  7. T

    Off Center

    Yes, my question is different. First of all I should mention that I'm doing open segments Using a degree platter controlled by a stepper motor (see attached picture). The segment widths calculated in Segment Pro vary the width of the wood for many of the rows. I round up the width calculations...
  8. T

    Off Center

    Sorry for the late reply. For some reason I could not find my post or the replies until today. I now understand why both sides of the segment don't align with the center after reading the replies. To sum it up then, measurements should be made to the ID of the segment and the measurement...
  9. T

    Off Center

    Can someome explaing how they handle centering a segment when they are using a standalone fixture for segment placement. Please refer to the attached picture for claification. If one edge of the segment is on the center line of the bowl the other edge is not pointing to the center. The segments...
See more
Back
Top