• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Adding spacers to design ring

Yes. (but only if you want too). lol

By doing so you just break up the pattern by the vertical insert. Be creative. It is your bowl.
 
I could not figure out the steps in Lamination PRO to add the vertical spacers
Gerald,
Vertical Spacers are added by the segmenting programs Woodturner PRO or Segment PRO. I just changed the way it works in Segment PRO and it is much better now. It currently only works if you're making a Feature Ring bowl which is, IMHO, the only place where it makes sense. On the front page, just specify the width of the Spacer and then use the combobox beneath it to let the software know to apply them only on the default rows, the feature ring or both the default rows and feature ring.

The spacer itself is a strip of wood that has parallel sides that is glued onto one edge of each segment. If it is 1/4" (for example), the amount visible is more than 1/4" because it is at an angle.

The Summary report now calculates the Segment Edge Length taking the Vertical Spacer into consideration.
 
Gerald.:
As Lloyd said adding spacers is done in WTP or SP. Lamination Pro is for making designs for a feature ring. So you cannot add spacers within the Lamination Pro program.
 
Back
Top