• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Status bar

stevemil56

PRO Member
My status bar in Lamination pro does not show the ring diameter. I want to make a plate but have no idea how to control the diameter.

Steve
 
Steve.

Lamination Pro is a bit different than WTP. It is more of pattern designer using laminated boards

- Have you designed your plate in WTP? If not, you should.

- WTP will give you all the info you need for each ring. for the plate.

- in LP, down in the bottom left of the screen is the repeating unit width when you select gen 1. That is the segment length.
- by changing the lamination cut width the repeating unit width will change. Select a width that most closely matches your rings segment length.
 
Thanks but what I am trying to do is create a flat disk which I will add a ring in woodturner pro like a frame prior to turning. I did figure out how to find the diameter of the disk in Laminationpro but can not figure out how to cut the segments. I posted another thread for that.

Steve
 
Back
Top