swd1blazer
PRO Member
In the summary you have the option to optimize board widths and segment edge lengths. Are these options good or not so good to use to get your final ring size?
Steve
Steve
-
Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.
Optimize board and segment lengths
- Thread starter swd1blazer
- Start date
Optimize board width
- will not impact final ring size.
- Based on your vessel profile it is a way to minimize the number of different widths of the strips you use to cut your segments.
Optimizing SEL
- Will not impact final shape. it basically rounds to the nearest 10th rather than base calculation showing to the nearest 1000th.
- it is a way to minimize the number of SEL change setups you have to do.
I tend to overbuild and turn down to final desired shape (outside and inside diameter).
- will not impact final ring size.
- Based on your vessel profile it is a way to minimize the number of different widths of the strips you use to cut your segments.
Optimizing SEL
- Will not impact final shape. it basically rounds to the nearest 10th rather than base calculation showing to the nearest 1000th.
- it is a way to minimize the number of SEL change setups you have to do.
I tend to overbuild and turn down to final desired shape (outside and inside diameter).