• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Cutting segments for feature ring

O

Ossie Pereira

PRO Member
I have a 20" long laminated strip with the diamond pattern.
My repeating unit says 2". I have 1/8" kerf in the option screen.
My Question is should i cut at the 2' mark and if
so, has the program calculated for the kerf if not, do i have add an extra 1/6 or 1/8 to the width of my chevron pattern in order to accommodate my saw kerf of 1/8".
Please advise as i have tried to get an answer in the forum section but could not find it.
Also what type of jig is most suitable for this application or do i have to use the laser method?
Thanks
 
- The repeating unit should be what your segment edge length is for the ring you are making.

- In cutting a laminate, one method I have done is to cut the segments into blocks. Using a center line through the diamond I would measure 1" to each side (SL=2"). Then I would use a setup similar to the attached incra sled example to miter the ends.


Here are a couple of threads you may be interested in.

Cutting Segments from Laminate Pro

I am just starting with trying to create a feature ring in a bowl. I have designed one using laminate pro. The process of creating the laminate and a Gen 2 board I understand. But what I am confusing myself on is how to cut this into segments and keep the pattern. Making sure everything...
woodturnerpro.com

At the 8:30 mark in the following tutorial, I show how to use the SW Design tool to make a diamond pattern.

09 - Using Lamination PRO with Segment PRO

Although you can make your feature ring segments using hundreds of different methods, there is no simpler way of designing them than using Lamination PRO. The key is knowing the two important dimensions that you have to know before you start using Lamination PRO: the height and width of the...
woodturnerpro.com
 
Ossie Pereira said:
I have a 20" long laminated strip with the diamond pattern.
My repeating unit says 2". I have 1/8" kerf in the option screen.
My Question is should i cut at the 2' mark and if
so, has the program calculated for the kerf if not, do i have add an extra 1/6 or 1/8 to the width of my chevron pattern in order to accommodate my saw kerf of 1/8".
Please advise as i have tried to get an answer in the forum section but could not find it.
Also what type of jig is most suitable for this application or do i have to use the laser method?
Thanks
Click to expand...
Thank you very much. Your explanation was very clear which has cleared all my confusion about laminate pro.
I am using my seg. easy sledge and used your advise of using the center of the diamond as reference for cutting my seg width.
my segments are now perfect with the diamond pattern in the dead center of my seg
I am now ready to explore the world of laminate pro with this powerful laminate pro application.
Thanks again.
 
You must log in or register to reply here.
Back
Top