Hello from nc.

Potter

New Member
I am fairly new to woodturning and i am so happy that i found this group, THANK YOU FOR LETTING ME JOIN !!!
 

mfisher

Super Moderator
Staff member
Welcome aboard.

WTP is a good place to ask questions and share experiences. The only bad question is the one you don't ask.:p

If you are not familiar with the WTP suite of software take the time to look over the training videos. While a few are based on older version of the software they still show the power of the tool. Wood Turner Pro give you full control of the design and ring. Segment Pro is the new version and is rules based. SP does not allow some aspect of the ring to be changed. Lamination Pro is a design pattern tool and can be used with WTP or SP.
3DDesign is free and is a profile design tool It works with WTP,

The software is free to download and use for 30 days. All of the software is fully functional.

Have fun learning. Turning and segment building can be addictive.
 

Potter

New Member
Thank you...my first question, what diameter is the stomper plunger ???
I am making my first stomper, and the only sprinkler I could get is made by rain bird, exactly the same, except it has a 3/4" diameter pplunger, and I wanted to know if your stomper has the same ???
THANK YOU!!!
 

mfisher

Super Moderator
Staff member
The following information from the WTP hardware section:

"The centering holes of the Longworth Centering Attachment are approximately 13/16" in diameter. As long as the plunger system you make has a diameter between 3/4" and 13/16" it will work with this attachment."

This another helpful link

It has been years since I built a box for the stomper. Can't remember the exact size. Stomper is at the woodclub shop.
I would suggest you contact Lloyd and ask your question. I believe you will be ok but not totally certain.
 
Top