• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Search results

  1. J

    Graphics

    Windows 11 has gone through many patches and upgrades. I plan on trying to install the problem ones and see if the needed updates were my problem. As always you and your staff have been very helpful and knowledgeable. Thank fisher for me. Jon
  2. J

    Graphics

    There were four Intel drives that needed to be updated, done and everything is running like it should. Thanks for the advise. Jon
  3. J

    Graphics

    Just wanted let you know that I uninstalled everything from the new computer and reinstalled all on my old computer (which is short in life, could go anytime). All parts of the package works fine, tells me it could be Windows 11 or the new computer, I'm leaning towards Windows 11. This is not...
  4. J

    Graphics

    Just found the Dizzy bowl example and it runs perfect in Woodturners Pro. Seems to be a Segment Pro problem. Jon
  5. J

    Graphics

    I installed Segment Pro and get the same results. I also tried Lamination Pro as well 3D Design Pro, all is Ok. Don't have any projects for Woodturner Pro so can't Tell. I've attached the new screen using Snagit.
  6. J

    Graphics

    Sorry about the misspelled word (vies) should of been view. I'm going to attached a PDF file of what I was talked or trying to explain. Also, is a PDF of how my graphics card is setup. I'm running windows 11 home edition and the processor is i7. As far opening the programs, I can open all four...
  7. J

    Graphics

    Hello everyone, New to using Segmented/ woodturners Pro. My question is that when I open either program my graphics vies is all mess up, or does show what it looks like. I use a Dell notebook with 1120 x 1080 resolution 120hz and RGB graphics card. Is there a setting that is not correct or...
  8. J

    New Member Introduction

    My name is Jon Grace and I’m a seated turner, because of the back. I’ve been turning for approximately four years, but only turned a paper towel holder with a segmented top and bottom. Read or reading several books on Segmenting bowls. Was wondering if there is any manuals for the programs.
Back
Top