• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Search results

  1. R

    Segment kick back

    The drop off was not even with the sled, it is now. Raising blade height really helped. I also added a cheezy cardboard roof which helped some. Photos attached are the seg set-up and a few of the shop at the retirement community where I live.
  2. R

    Segment kick back

    Thanks, I'll check the ramp height. My shop is a community shop at a retirement community. So, I'll need to wait till morning to check it. The photo does appear to be low. FYI I am going to make a new sled more to the drawings then the one pictured.
  3. R

    Segment kick back

    Any help on why small edge length segs are kicking back. They usually hit my length stop and bounce out of sight. Photo of set up is attached.
  4. R

    Sanding small diameter rings

    Tape held real well, thanks for your help!!!!
  5. R

    Sanding small diameter rings

    Thanks for your help, I'll try the tape method today.
  6. R

    Sanding small diameter rings

    I wasn't sure tape would hold, I'll try tape. On the lathe would I use a tool or sanding board? With either method is .010/.015 " oversize enough to work with? Is the side rail on the backing board to compensate for side movement caused by the helix on the sander drum roll, no pun intended.;)
  7. R

    Sanding small diameter rings

    My surface sander needs a 6" diameter ring to reach across infeed to outfeed rolls. I would like your ideas on sanding small rings. Thanks, Rich E.
  8. R

    Aligning rings

    Thanks, I will check out the Stomper. I first thought the the Stomper was for open turnings.
  9. R

    Aligning rings

    I need some help on how to align segmented rings for gluing. Sometimes the run out i get is beyond what will clean up round.
  10. R

    Hello

    I'm a retired toolmaker, lot's of experience with metal cutting on several types of lathes, just learning wood turning.
Back
Top