• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Search results

  1. martyn

    barley twist vase

    The story so far Ok i plan on posting how i like to finish a project using multiple layers of finish and then sanding and polishing so i figured i may as well post the construction of the vessel too. unfourtunatley didn't fully document the construction of the feature ring so if its a bit...
  2. martyn

    advice on bowl

    hi i am making this bowl and I've just put the two sides together and it looks all wrong i think what i am going to do is trim the maple layer above the feature rig down to about 4mm then add another walnut layer to the top half above the new thin maple layer re shape round cut off the first...
  3. martyn

    box jig

    finished this yesterday i had two linear bearing left, lead screw and some pulleys so i built this box jig. The lead screw was a 2mm pitch t8, so i put a 20 tooth pulley on the end of the lead screw and connected it to a 40 tooth pulley which drove a rotational counter, this meant that the...
  4. martyn

    Slot mortising jig

    ok i know this has zilch to do with segmented turning but I've spent the last couple of months developing this jig. The jig started in plywood using drawer runner which was too unstable, which caused me to rebuild it in 20mm pvc plastic sheet buy a new bigger router and buy two set of linear...
  5. martyn

    steady rest for tall segment vessels

    i haven't seen any references to steady rests on the site so that y I've posted this. I am currently working on a open segmented vase and have just glued the two halves together an tried to turn the top but getting a lot of vibration, i new i needed a steady rest and i could find one to buy...
  6. martyn

    Sapel Beech and Walnut vase

    Finished this vase today after having to repair it after it bounced off garage floar upon finishing polishing it up last time, its been one of those turning that nearly ended up in the bin a few times. i used some beech that i bought off ebay for the main body and it is the first time I've...
  7. martyn

    Oak and sapele segmented urne

    with this segment turning i went a bit mental, it wasn't planned at all i had just got my table saw and built my first sled, i just started cutting segments and making rings, and sticking it all together. The lid laminated with a plug in the middle and a ring glued on the bottom to create a...
  8. martyn

    cross vice flattening rings

    was spending hours sanding rings flat on sanding disc for lathe suffacating in dust so i decided to mount a cross vice on my lathe just like a metal lathe, now it takes less than a minute to true a face up, i put loose rings on the lathe using my longsworth chuck to flatten the first side of...
  9. martyn

    table sled cutting segments

    this is my table saw sled i built for my axminster ts250 table saw, ives used two layers of 12mm birch plywood laminted together, they run on nylon runner on the table saw grooves. i used a router to put 2 arched t grooves in the bed in which the fence swings and locks in. The right side of the...
Back
Top