• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Search results

  1. A

    segmented vase

    I built this with a Seg Easy Sled and the Segment Stomper with the Longworth chuck. I guess I should have used a laser as a few are off. I took a picture off of the net and put it into Design Pro and then into Woodturner Pro. There are 20- 3/4" rings of Walnut and Maple and 2 - 1" rings of...
  2. A

    adding spacers

    Hello it's me again. I have another question. Is there a way to add 1/8" spacers between segments in a closed form in WT pro. I know how to calculate it on paper but can not find out how on WT pro or if it is possible. Al
  3. A

    finaly some time to turn

    This was my first try with the Seg Easy sled and the segmented Stomper. Both worked as well in person as they do on the Utube vids. The sled makes flawless segments and the Stomper sure makes it easy to line things up The piece is made from Bloodwood and Gaboon Ebony . There are 32 pieces per...
  4. A

    need a fudge factor

    When I do up a drawing in 3D pro and transfer it to Woodturner Pro is there any way to get a little more meat on the OD. When I look at the individual ring the ring comes right to the edge of the segment. is there a way to increase the OD of the ring prior to turning. Just looking for a bit of a...
  5. A

    Importing photos

    Can you import a photo and then set it up and then start to put in the rows the way you want. I got a photo transferred but can not figure out how to start drawing the rows can this be done
  6. A

    stomper

    Does anyone have an alternative to drilling the shallow 5/8 hole in the bottom of the vessel or bowl to accomadate the threased end (top) of the stomper. They say to just turn it out when you are done. I do some pieces that are too deep to do this.
Back
Top