• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

Search results

  1. J

    Cut list or support for required total species length

    In the summary view there are columns labeled width and length (towards the end and they aren't populated per ring). what are these meant to be? Is it an attempt at given the required amount of material needed for a specific species. My project is 19 rings of walnut and a solid base - i was...
  2. J

    Bug if using metric

    If I set things to metric, the summary still shows inches for some of the columns. i.e. the 207.5 mm is the same as 8.2 inches - is this a known bug or a way to fix?
  3. J

    Layout of the rings

    Is there something that shows the distance between each ring to aid in glue-up? In the main imagine of the bowl it does show a layout but there is nothing obvious to me that is showing how far each ring should be from the previous as a glue-up guide to help - or just visually center the ring is...
  4. J

    The ring view is not showing anything of the detail

    See my attached ring view - it just shows each ring, but there is nothing about each ring. Is this because I still am playing around with the trial version?
Back
Top