Search results

I didn't mean to imply that I have a digital readout on my scale. It's just the ordinary stick-on tape with magnifying lens, but it is calibrated so 1" reading IS 1.0 inches between the fence and the fence side of the blade. With the setup I have, the sliding 'wedgie' fences are on the other...

LOL! I may have mentioned that this is my first segmented turning... As long as the ring is thick enough to allow me to, uh, 'deviate' from the prescribed profile without cutting through the wall, I'm good with it. As it is, Segment Pro has this nice feature where I can indicate that I am a...

Thanks for the fast reply. Your explanation makes sense, but where I was stuck is how to set the stop distance given the data from the summary page. Using the cosine to adjust the S.E.L works perfectly. My stop is a 5" block of maple clamped to my tablesaw fence (to provide plenty of...

I am using Segment Pro for the first time (first time doing a segment bowl at all!) and I'm not sure what distance, from the cut line, to set the stop. I had assumed that I would use the S.E.L number from the Summary page, but my first test pass ended up a larger diameter than Segment Pro...