• Having problems with video with Segment PRO on a new PC? You could be experiencing one (or both) of two problems. First, if you have an ultra high-resolution screen, the recommended settings might be higher than 1920 x 1080 with a scale factor of more than 100% and the user interfaces for all software written in c# will NOT be correct. Simply change the resolution and scaling to 1920 x 1080 and scale to 100%. Second, if you have a wonky Bowl View, you have an Intel Iris graphics solution and there are serious problems with it. Solution - go to the Drivers page at Intel's website and install their latest driver for your computer. This will fix it. Link: https://www.intel.com/content/www/us/en/download-center/home.html

Search results

  1. S

    Measurements

    I appreciate you taking the time to respond, I wouldn't have;). Especially traveling. When i did the bowl I played around with all the features, clicking through them, I'm pretty sure I left a entry in the spacers field. This seems to change the SEL, but not the diameters when i played with it...
  2. S

    Measurements

    I appreciate it, I’d have figured I’d it was a painted bowl changing the size would matter more … I’ll look at it again when I’m home and start from scratch. Out of curiosity did you get the same cut lengths?
  3. S

    Measurements

    I’m sure it’s on me…. I think I may have changed a measurement in the wrong step along the way to finalizing what I wanted…. Doing a little digging I can see that may affect it?
  4. S

    Measurements

    I appreciate the help, attached is the file.
  5. S

    Measurements

    Hey all, new to the software and segmented turning… so I’m sure it’s operator error here. My ring outside diameters aren’t matching up with what the software says it should be. Ring 6 is shown as an example, I’m over a half an inch short on my diameter.I checked my calipers against the...
Top