Search results

  1. Ed Reed

    simple disc in Lamination Pro

    Thanks for the response. I saw the red lines in the software and the instruction to "Cut through intersections of red lines" but there are no dimensions as to where those red lines intersect. Just eyeballing it isn't working for me. I need some dimensions to use to get to the intersection of...
  2. Ed Reed

    simple disc in Lamination Pro

    This is representative of the problem I have. My chevrons are even when I build my lamination, but when I go to cut the wedges for the disk they are not even in both sides.
  3. Ed Reed

    simple disc in Lamination Pro

    I'm able to create the first gen lamination fine. I glue the pieces up in pairs so that my chevrons come out equal. Then I glue those pairs into new pairs of two chevrons and so on until I get my completed lamination. My problem occurs after that when I try to create the disk. No matter what I...
  4. Ed Reed

    simple disc in Lamination Pro

    I read the same thing but it's not helpful. My cut pieces come out with too much variation to make a perfect circle and the chevrons are not equally sized.
  5. Ed Reed

    simple disc in Lamination Pro

    Are there any video tutorials for how to produce a simple 1st generation disk in Lamination Pro? I'm struggling trying to make a disk with equally spaced chevrons. Thanks
  6. Ed Reed

    New WTP design I call "Large bowl with too many pieces"

    I saw this design on a gallery website and wanted to reproduce it with WTP. I have not made this bowl yet but I plan to start this weekend. If anyone has any comments or suggestions I would certainly welcome them. Enjoy.
  7. Ed Reed

    different size segments within a row

    Thanks for the response. I was afraid that would be the answer but I wanted to check. I did come up with a design in WTP that has the same look. I basically figured the brown segments approximately equaled nine of the individual white or black segments with that count I duplicated the pattern...
  8. Ed Reed

    different size segments within a row

    Using WTP, is it possible to create a design with different size segment in the same row? I want to do something like this. I know I can change the thickness of every other row but I can't figure out how to make the three narrow segments followed by one wide segment, and repeat. Any thoughts?
  9. 229 pieces - Maple, Rosewood and Pupleheart

    229 pieces - Maple, Rosewood and Pupleheart

  10. 229 pieces - Maple, Rosewood and Pupleheart

    229 pieces - Maple, Rosewood and Pupleheart

Top