Recent content by Kyle Stubbins

  1. Kyle Stubbins

    Help with cutting very low miter angles on staves

    I actually messed that up a little... I have a double digit angle guage. I need a triple digit angle guage.
  2. Kyle Stubbins

    Help with cutting very low miter angles on staves

    Thanks for the link. I have a stave jig / sled that I use and don't really have any problems cutting them. It's just that I can't figure out how to measure less than 1 degree accurately to set the miter. The staves for these were 1.1 degrees. Easy to set and cut. Which brings me to another...
  3. Kyle Stubbins

    Help with cutting very low miter angles on staves

    Sorry, should have thought of attaching the wtp file. I was also looking to see if I could export an image to show the vessel view as well, but I didn't see one. Good idea for the accent rings. That simplifies it. Thanks for the link. I read that one yesterday and was interested in the wedge...
  4. Kyle Stubbins

    Help with cutting very low miter angles on staves

    Hi all; I've been designing a table base for a client that wants to cover a well (42" in diameter) with a large oak barrel looking table. I'll attach the project. I bought 65 board feet of 8/4 oak. So when I was designing, I tried to figure out the best way to cut up the wood for efficiency...
  5. Kyle Stubbins

    Another hello from Ontario, Canada

    Hi all! My name is Kyle. I've been using all of Lloyd's software for a year or so now and love it. Never really have many questions, and most answers I've needed were easily found, so I've never really had much to say. Got a question on a project I'm working on today though, so thought I'd...
Top