bob g

Discussion in 'Bowl From A Board Forum' started by Bob Griffin, Mar 24, 2015.

  1. Bob Griffin

    Bob Griffin PRO Member

    using WTP I want to add vertical veneer strips between the segments of a flat segment ring. I haven't seen where there is a resize tool, that would allow dimensioning of the veneer strips in the menu. I see the veneer ring tool in the menu, but it refers to horizontal ring setups. I have used that with good results.
     
  2. Bob Griffin

    Bob Griffin PRO Member

    hey, I just saw a post about my question that answered it. thanks
     

Share This Page