New Member Introduction

jw23ea15

PRO Member
My name is Jon Grace and I’m a seated turner, because of the back. I’ve been turning for approximately four years, but only turned a paper towel holder with a segmented top and bottom. Read or reading several books on Segmenting bowls.
Was wondering if there is any manuals for the programs.
 

mfisher

Super Moderator
Staff member
My name is Jon Grace and I’m a seated turner, because of the back. I’ve been turning for approximately four years, but only turned a paper towel holder with a segmented top and bottom. Read or reading several books on Segmenting bowls.
Was wondering if there is any manuals for the programs.

Hi Jon:
Welcome to WTP forums.
The short answer to your question is there is no printed hardcopy manual for any of the software.

- WoodTurner Pro has a user guide built within the software under Help.
- 3DDesign Pro has a user guide built within the software under Help
- Lamination Pro has a user guide built within the software
- Segment Pro Help links to the video tutorials on this website.

The link here is to the webpage with the tutorials for all the sofware.
 
Top