Hi all,
Brand new to the software. I am getting calculated segment lengths like 1.053, 1.137 etc and was wondering if you round up, down, or do you have calipers that measure out to the 1000ths. If you round up or down what’s the rule of thumb? Do you add wall thickness to compensate or is that really not nessesary as the numbers are so small?
thanks in advance,
Brand new to the software. I am getting calculated segment lengths like 1.053, 1.137 etc and was wondering if you round up, down, or do you have calipers that measure out to the 1000ths. If you round up or down what’s the rule of thumb? Do you add wall thickness to compensate or is that really not nessesary as the numbers are so small?
thanks in advance,