Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.
I work in millimetres , but in Laminate Pro the first cut width is only in inches. Apart from having to convert inches to millimetre's the available choices in inches do not always coincide with the metric conversion.
Thanks Peter. I remember now that this is an issue a while back. Just for grins I downloaded LP and installed the program. Went in and changed the option to metric. Created a lamination. What I did get was the drop down for cut width is metric. Measurements along the bottom are in inches and metric.
I’m not aware of any calculations that do not show in both imperial inches and metric. If you are on the latest version and know of fields where this is not the case, I’d appreciate it if you would let me know about them and I will get them fixed.
The Downloads page of the website has the software installers and each installer shows the build number of that installer. If it is bigger than the version you have installed, you should install the new build. You don’t need to uninstall your version. The new install will do this for you. You also won’t need to renter the authorization code.