• Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.

extending the plunger on the Stomper

D

David Baldrich

Guest
Does any one have a good idea on how to extend the plunger so it can be used to glue up vessels taller than 10 in. My current thought is to thread a section of pvc pipe and screw it to the treads on top.
 
Or build the vessel in two halves (top / bottom), then join them on the lathe. I would be concerned with the shaft deflection as you get taller.
 
Some taller vases that I have done were certainly done in two sections, one was even three sections. Another that I did that was 12 inches tall I turned as I built each layer and sometimes adding two layers. I normally add each ring on the lathe so it does tie up the lathe while glue dries. I like to allow about 2 hours before I will attempt to turn a ring. This is my hobby so the time element is not that important to me.
 
If you go to Amazon and search for ‘sprinkler riser extension’, you’ll find just what you’re looking for. They come in a four pack and just thread on to the existing riser.
Lloyd
 
If you go to Amazon and search for ‘sprinkler riser extension’, you’ll find just what you’re looking for. They come in a four pack and just thread on to the existing riser.
Lloyd
Thank you . I think they would be perfect as they are 6 in. lengths .
 
Back
Top