Lynn Chastain
PRO Member
Using a ring dia of 7" outside,4.5 inside dia 48 Segments WTP shows an Econo Board length of 61.61". Can this be right, the circumference is only 21.99" or is it a mistake in the program?
-
Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.
WTP calculating board length
- Thread starter Lynn Chastain
- Start date
Not sure what happened for you. I opened WTP and made a ring with your specs 7" od, 4.5 id, 48 segments.
results:
SL = 0.46"
Board width = 1.25"
economy board = 24.4"
grain match = 28.26"
I have a few questions
- Have you tried deleting the ring, adding it back in with your 7"od and 4.5" id. ?
Did that fix the problem.?
(I would close WTP, restart it and then do the ring deletion and addition) assumed you have saved the project.)
If that didn't fix the issue I would take the summary sheet for your plan and recreate the project under a new file.
If that doesn't fix it, you could attach your *.wtp file so we can take a look at it and see if we can find the issue.
results:
SL = 0.46"
Board width = 1.25"
economy board = 24.4"
grain match = 28.26"
I have a few questions
- Have you tried deleting the ring, adding it back in with your 7"od and 4.5" id. ?
Did that fix the problem.?
(I would close WTP, restart it and then do the ring deletion and addition) assumed you have saved the project.)
If that didn't fix the issue I would take the summary sheet for your plan and recreate the project under a new file.
If that doesn't fix it, you could attach your *.wtp file so we can take a look at it and see if we can find the issue.
Last edited: