Missing kerf option in Laminate Pro

Discussion in 'Lamination PRO' started by Ed Korsberg, Apr 21, 2019.

  1. Ed Korsberg

    Ed Korsberg PRO Member

    I am new to these tools but in reading the help for Laminate Pro it talks about the option to show kerfs. But the software I have it not showing that option.
    Title: Imgur
    Title: Imgur

    I know that software changes over time with new revisions. However the help supplied with this version states this feature is available whereas the software does not seem to support it.
     
  2. mfisher

    mfisher Super Moderator Staff Member

    What version of LP are you running? (Help/about will give you a pop up window that gives the version numbers.
    The help file may not have been updated to reflect the current program. version 3.2.018 is the latest.

    In file / options you can select your saw blade width/kerf. 1/8" , 3/32", or none. Most common blades is 1/8"
    When you set the blade kerf you will see four parallel black lines cutting through your laminate. That is the kerf line for the cut.
     
  3. Ed Korsberg

    Ed Korsberg PRO Member

    The Help -> About states the version is build 3.2.020
     
  4. mfisher

    mfisher Super Moderator Staff Member

    Thanks. That is the latest version of LP
    Lloyd can correct me if I am wrong, but the kerf button in the help file is from older versions. The button was just a toggle to turn on or off the kerf. It looks like the help file has not been updated to reflect the change.

    The width of the kerf is set in the options section. The number of kerf options was increased in version .020. My guess Lloyd took out the kerf button because it served no real purpose.
     

Share This Page